After seeing Dr Go's new G3 splitboard skins an how they clip on I had to try a set.
Problem is that Iam using them on a Hovercraft, so the tail clip did not work out that well.
So after looking at it for a couple minutes I had an idea.
I should have taken a before picture - it would be easier to show what I did than tell!
So I cut the tail clip in two about 2/3 in from the leg that hooks on the inside edge of the snowboard.
Then TiG welded the right piece on the left one and the left one on the right one.
I think it's going to work real well.
So I bought the long version of these for my 156 hovercraft.
Problem is that Iam using them on a Hovercraft, so the tail clip did not work out that well.
So after looking at it for a couple minutes I had an idea.
I should have taken a before picture - it would be easier to show what I did than tell!
So I cut the tail clip in two about 2/3 in from the leg that hooks on the inside edge of the snowboard.
Then TiG welded the right piece on the left one and the left one on the right one.
I think it's going to work real well.
So I bought the long version of these for my 156 hovercraft.
